Search the forum,

Hi all - a short Introduction

Post new thread

Discuss Hi all - a short Introduction in the The Welcome Wagon :) area at PlumbersForums.net

C

CAMCAP

Messages
2
 Hi Everyone.
Although retired my background is industrial and in the field of process control instrumentation, most of it in the oil &gas, petrochemical and industrial and sanitary wastewater industries. I therefore have an understanding and interest in plumbing but not a plumber however I enjoy reading the many topics, opinions and inevitable differences and consequent banter!
 
Hello and welcome
 

Reply to Hi all - a short Introduction in the The Welcome Wagon :) area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
168
Lou
Lou
B
    • Friendly
Posting a thread as until now I've only read the forum
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
2
Views
172
turnpin
turnpin
A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
291
oz-plumber
O
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
545
Chuck
C
C
Y Plan, no hot water but heating is working when called
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
326
John.g
J
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrician Talk Forum
British Standards in Tiling BS5389
Tilers Talk
Tilezine Tiling News Tile Association
Plumbing Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock