Search the forum,

Connecting Bath waste pipe to hose outlet

Post new thread

Discuss Connecting Bath waste pipe to hose outlet in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

G

GingerDoughnut

Hi Folks, I want to connect a bath waste outlet to a hose, but I'm struggling to configure it. It's for a temporary rainwater collection system that's being installed on a remote farm. I need to get from the plughole to a connector that will fit a hose. But I keep drawing a blank, but I'm sure it can be done.
 
Yes it can be done with fittings below simply solvent weld the adaptors in each end of the Hep flex and your back to normal 40 mm solvent weld pipe . Kop
 

Attachments

  • Screenshot_20230516-191027.png
    Screenshot_20230516-191027.png
    251.3 KB · Views: 12
  • Screenshot_20230516-194431.png
    Screenshot_20230516-194431.png
    149.4 KB · Views: 15

Reply to Connecting Bath waste pipe to hose outlet in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
dreikher
dreikher
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
264
ShaunCorbs
ShaunCorbs
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
323
Chuck
C
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
242
Chuck
C
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
119
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forums
Electrical Advice | Electricians Blog
Tiling Blog
Electrical News
Tilers Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock