Search the forum,

Can anyone identify this shower mixer?

Post new thread

Discuss Can anyone identify this shower mixer? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

Masood

Customer thinks it might have come from Bathstore but not sure.

The words cast into the body say "TOP REV" on one side and "TOP NORM" on the other. I've emailed Shower Doctor as well, but if anyone knows I'd be grateful.

2015-12-05 10.43.49.jpg2015-12-05 10.59.40.jpg2015-12-05 11.04.12.jpg20151205_110719.jpg
 
Status
Not open for further replies.

Reply to Can anyone identify this shower mixer? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
176
Lou
Lou
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
236
SimonG
SimonG
Stigster
Does anyone know the name of this model of Roca toilet?
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
163
Stigster
Stigster
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
220
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Cutters
Tiling Advice
DIY Forum
Electrical Forum
Electrical Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock