Search the forum,

Discuss Boiler service by manufacturers £? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Scott_D

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,131
Anyone know how much manufacturers charge to service a boiler?
Just curious:shades_smile:
 
is that a strip down service, or a combustion and statutory check all ok, happy days service?
 
Is that the pre curser to how long you are willing to stay in the house then mas ?

Definitely! Mingers get a quick FGA and gas rate. Hotties get the Full Monty dance routine. Or an injunction... :smilielol5:
 
I used to have boiler cover with BG.

A service was included.

They never stripped or took anything off other than the front cover, ever.
 
Status
Not open for further replies.

Reply to Boiler service by manufacturers £? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
  • Question
Boiler is SIRIUS THREE FS 70 Potterton commercial. Situation: We are small building contractors and my labourers managed to damage the radiator pipes during the strip out. Not the end of the world as damages happens. I am responsible builder and paying my bills and to repair the damages if...
Replies
2
Views
60
Has anyone one fit or serviced one of these before; Heatrae Sadia 25l 9004010. It a 25 litre hot water storage cylinder.
Replies
39
Views
731
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
241
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
224
Hi all, this is probably a daft question but I need to run my cold feed from one side of my wall mounted boiler to the other. Running it beneath the boiler is difficult with lots of obstacles, is it okay if I run soldered copper over / across the top of the boiler? It'll be about 4" off the top...
Replies
2
Views
176
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock