Discuss Baxi Platinum dodgy hot water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

Aquariusplumb

Hi all can someone help me. Baxi platinum boiler works great in ch mode, turn tap on green neon comes on, red Hall effect sensor comes on, boiler fires but water foes hot then cold. Sometimes hot water runs warm but never really hot. Felt hot pipe under boiler with bath tap blasting and pipe doesn't really heat up! Plate heat exchanger partially blocked? Thanks
 
Il have to check tomorrow. It's only been fitted 3 weeks just wondered if it was something simple before I call the heat team out to it.
 
Il have to check tomorrow. It's only been fitted 3 weeks just wondered if it was something simple before I call the heat team out to it.

3 weeks? As long as you know the system was flushed and cleaned best you could then I'd be kicking it to them ... could be a dodgy Phex?
 
Yeah I had It running for an age with chemicals in and out constantly cleaning the magnaclean til there was nothing sticking to it and checked it today when I popped in and was clean. Never had a problem like it with these boilers. I suspected the phex. Oh well heat team here you go.
 
Don't shoot me down okay... Fitted an Apollo for a landlord a few months back ... just wouldn't work on heating or water! Kept overheating! Ended up replacing it!! Over the years seen loads of issues on installation. Just send it back to manufacturer! Not good when the custard has to live with a dodgy boiler but what can you do? :)
 
Myson Apollo ( super sexy band k rated? ) for DHW check that the diverter head is working properly, I would assume so as ur getting CH but not domestic. Is Hall effect a constant light or weak flickers? Had odd instance where sensor was bunged up. Also u have got hot and cold in correct orientation? I have NEVER done this tho. Works for few days then intermittent. Also mixer tap or shower passing? Fit a check valve or two?
 
bet you a mars bar the lead field engineer says its a installation fault knowing full well something on the boiler has been massed produced wrong not that thats ever happened to baxi - NOooooo
 
Heating works great, hot water works great, when heatings on and you turn the tap on it's just luke warm. Been on the phone to baxi and they say diverter valve or motorised head so heat teams out tomorrow.
 
Status
Not open for further replies.

Reply to Baxi Platinum dodgy hot water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all, just moved a radiator from one wall to another, straight forward job, heating is working, problem is that on turning on a hot water tap...
Replies
5
Views
570
The Water Board have just replaced the main water supply to our property. We have a ground floor combi boiler. The central heating system for the...
Replies
9
Views
571
M
Hello, We’ve recently moved into a fairly old, fairly big detached house (i.e. fairly draughty, but not too bad by any means) with a fairly new...
Replies
0
Views
289
MartinPod81
M
Afternoon. I have an issue with no water flow from any of the hot taps in the house, I can't seem to find a solution to the issue. System is a...
Replies
11
Views
367
Looking for any ideas to help. I've a Heatrae Sadia Hot Water tank, heated through Oil fired boiler (working fine). A week ago I reset the air...
Replies
8
Views
349
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock