Discuss Armitage tap circlip in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

pramsrmike

Can anybody help me locate a circlip for a 15 year old Armitage tap. It is shaped like 3 sides of a square, rather than the conventional circular shape. If anybody can help me, I would be very grateful, as I really don't want to buy 2 new taps for the sake of a lost washer!
Thanks in advance,
Mike
 
Hello pramsrmike and welcome try your local independent merchants they normally have a box of bits and pieces ....if not drop an email to armitage shanks good luck:) regards turnpin
 
Tried my local merchants - no luck. Will try A.S. Thanks for the info.
 
Status
Not open for further replies.

Reply to Armitage tap circlip in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
234
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
295
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
310
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
246
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The...
Replies
6
Views
282
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock