Search the forum,

Armitage tap circlip

Post new thread

Discuss Armitage tap circlip in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

pramsrmike

Can anybody help me locate a circlip for a 15 year old Armitage tap. It is shaped like 3 sides of a square, rather than the conventional circular shape. If anybody can help me, I would be very grateful, as I really don't want to buy 2 new taps for the sake of a lost washer!
Thanks in advance,
Mike
 
Hello pramsrmike and welcome try your local independent merchants they normally have a box of bits and pieces ....if not drop an email to armitage shanks good luck:) regards turnpin
 
Tried my local merchants - no luck. Will try A.S. Thanks for the info.
 
Status
Not open for further replies.

Reply to Armitage tap circlip in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
138
Lou
Lou
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
DIwhYdidIstartThis
D
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
234
Dave Moore
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
149
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical Advice | Electricians Blog
DIY Forum
Tiling Tools
Tilers Forum
Contractor Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock