Search the forum,

Anyone recognise this tap?

Post new thread

Discuss Anyone recognise this tap? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
W

WaterTight

Esteemed
Plumber
Subscribed
Messages
5,439
6xzs0o.jpg
 
I don't recognise the make unfortunately. The other "unfortunately" is that you shouldn't really be replacing that tap with another pull out spout type because it's near impossible to make it comply with water regs due to being a high backflow risk situation (basically needs to be treated the same way as a bidet with its own break tank which nobody will ever do). I would replace it with a non-pull out spout design of your choice.
 
Status
Not open for further replies.

Reply to Anyone recognise this tap? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
204
ShaunCorbs
ShaunCorbs
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
139
Lou
Lou
R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
3
Views
142
ShaunCorbs
ShaunCorbs
B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
301
Bp89
B
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
339
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forum
UK Tiling Forums
Tile Advice
Tile Cutters
Electrical Advice | Electricians Blog
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock