Discuss 110mm shower gulley help in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
8
Hi folks - I'm after some help with a shower trap that I need.
I've got a 110mm pipe popping up for a shower/wet room and I need a trap that'll fit straight onto the pipe - preferably one with a male spigot.
The only one I can find is the multiquick version but can't find any info about the connection.

Many thanks for any advice
 
Mcalpine do a range of floor drains cheers kop

Screenshot_2017-09-11-20-43-21.png


Screenshot_2017-09-11-20-56-25.png


Screenshot_2017-09-11-20-56-56.png
 
Thanks King - I know McAlpine do a huge range, trouble is they only do one with a vertical outlet and it's exactly 110m so you need a straight coupler to connect to a pop up.
I'm looking for one a bit like a pan connector with a male spigot end - that would save digging out a foot of concrete. I couldn't do that anyway as there is a 90 degree bend just under the surface.
I'll keep hunting,
Best regards
 
Hi again - KOP. Just had another look at the info you put up and seen exactly what I'm after!
Strange as I've been searching for ages and those two traps have never come up in my searches.
Anyway thank you for your help,
Kind regards
 
Status
Not open for further replies.

Reply to 110mm shower gulley help in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
235
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
295
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
232
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
Replies
1
Views
331
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
246
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock