Search the forum,

Discuss Worcester Bosch 8000 Life 35 to replace High Flow 400 in the Central Heating Forum area at PlumbersForums.net

Messages
1
Hi.. Advice please regarding a new Worcester Bosch 8000 Life 35 for a 4 bed detached with ensuite and currently powerful shower which is great. We currently have an old High Flow 400 . I understand heat output will be the same on a 40 / 45 / 50 model but will the 35 be sufficient especially regarding water flow rate to the shower? Thanks
 
Your highflow has a built in store for HW.
The store will give more even temp even when demand changes during use.
No normal combi will be the same but some attempt to compensate with higher HW output (more KW).
So altho a larger output combi can deal with the flow rates of multiple bathrooms they are still doing it on demand and temps may fluctuate more than with a store.
I would look at a viessmann 111-w If you don't want a separate unvented cylinder.
(Unvented cylinder and system boiler should always be 1st choice for larger properties imo)
 
Do WB do a wall mounted stoarge combi?

OP...there is cost implication but I'd try and replace for like for like especially as you seem very happy with the performance. I have no experience with the WB 8000 L35 but the flow rate appears to be around 13L/m compared to the current WB 440 Highflows of 20L/m. I didn't look hard enough to see at what temperatures.
 

Reply to Worcester Bosch 8000 Life 35 to replace High Flow 400 in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
115
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
97
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
284
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
229
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
191
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock