U
Unregistered
Hi i am interested in fitting a thermostatic shower valve in my house and was wondering what type of valve i need because the cold water is mains fed and the hot is low pressure can anyone help, thanks
Discuss steve in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 12,702
Forum rules ask that you register as a member then we have no confusion over posts and replies will be given. Thank you.
D
Dotty
Please register with us and start a new thread to receive an answer to your question.
P
PlumbBobBob
and you don't need to put your name as the subject of the thread
- Status
Reply to steve in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Can anyone remember the Mira mixer shower that would work down to a really low pressure on a vented hot water system without a shower pump?
Hi
Does anyone recognise the make/brand of the radiator valve. It leaks when closed and Iam hoping I can replace a seal etc?
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
- Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...