Search the forum,

Shower Enclosure HEEEEEEEEEEELP

Post new thread

Discuss Shower Enclosure HEEEEEEEEEEELP in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
E

EPH

Plumbers Arms member
Plumber
Messages
1,182
Cut a long story short I'm desperate for an enclosure to fit on a 730 x 670 tray.

Anyone know now of anything suitable, DIY store will do.

Many thanks.
 
Status
Not open for further replies.

Reply to Shower Enclosure HEEEEEEEEEEELP in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
168
Lou
Lou
S
tanking. Is it ok to just seal everything with plastic.
Hi All, I am looking to take my bath out and fit a shower. Regards to tanking. Is it ok to just seal everything with plastic rather than just paint tanking slurry? Thanks in anticipation, best regards Staggers
Replies
3
Views
247
fowlerboi
F
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
545
Chuck
C
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
6
Views
222
127bit
127bit
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
237
mutley racers
M
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forums
Tiling Tools
Contractor Advice Forum
Tiling Forum UK
Tile News
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock