Re: Connecting vented hot water cylinder to mains pressure

Post new thread

Discuss Re: Connecting vented hot water cylinder to mains pressure in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
H

hoveplumber

Just saying hi.

Craig West
 
Last edited by a moderator:
See it done.

Made a mess
 
Can't understand all this:

Thread started in April 2010 by a banned "member" (although I'd choose another word for this ...)

Thread not responded to until March 2012 ...
 
New posts
Status
Not open for further replies.

Reply to Re: Connecting vented hot water cylinder to mains pressure in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

M
Mixer mixer shower, compatible with tanked supply
Can anyone remember the Mira mixer shower that would work down to a really low pressure on a vented hot water system without a shower pump?
Replies
2
Views
171
Last Plumber
Last Plumber
M
heatrae sadia 25l 9004010.
Has anyone one fit or serviced one of these before; Heatrae Sadia 25l 9004010. It a 25 litre hot water storage cylinder.
2 3 4
Replies
39
Views
824
John.g
J
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new...
Replies
2
Views
243
ShaunCorbs
ShaunCorbs
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
223
Lou
Lou
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
223
Lou
Lou

Newest Plumbing Threads

Back
Top