power flushing time scale pluss filter

[Ermintrude]

Where from? Lid gasket or cross threaded legs?

 

[Leo21]

Where from? Lid gasket or cross threaded legs?

At least two lids, one just refused to tighten down after being in a year and quite a few on the olives, either the olives were rock hard or the threads to tight.

 

[Ermintrude]

Older olives were because stump into valve was too short . Lids come with replacement seals in box. On tf1 you have to replace every time you remove lid?

 

[Leo21]

Older olives were because stump into valve was too short . Lids come with replacement seals in box. On tf1 you have to replace every time you remove lid?

Ypu don't have to take the lid off, which makes it easy for the custards. And all the lids need is a clean and some silicon grease.

 

[Ermintrude]

Ypu don't have to take the lid off, which makes it easy for the custards. And all the lids need is a clean and some silicon grease.

Not according to mfr.

 

[Kyle87]

Older olives were because stump into valve was too short . Lids come with replacement seals in box. On tf1 you have to replace every time you remove lid?

I've taken a few tf1s to bits and never replaced any seals. All been fine