Search the forum,

Portfolio help

Discuss Portfolio help in the Gas Engineers Forum area at PlumbersForums.net

S

Shane_1

Messages
1
hello everyone

My name is shane I’m currently on my gas course i wanted to know if there is anyone in the west / South Yorkshire area who could help me with my portfolio I know it’s a strong shout as most of you are flat out.

I’m leaving the military after nearly ten years and I was a bit clueless on how hard it would be to find a placement with someone. If anyone can help me please give me a shout.

thanks again

shane
 

Reply to Portfolio help in the Gas Engineers Forum area at PlumbersForums.net

Similar plumbing topics

jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
303
oz-plumber
O
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
213
mutley racers
M
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Lou
Lou
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tilers' Talk
Tiling Standards BS5389
Tiling Tools
Tiling Tools for Beginners
UK Tiling News
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock