Search the forum,

Discuss Plumbing jobs in York? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
C

charliec1992

Hi I am 17 years old and looking for a plumbing job,
so far I have sent off to many different companies in York although heard nothing good back due to the economic climate.
I have so far passed the JTL course and I am on their pre-approved list however to get onto their training scheme I need to have an employer. Also I got a interview at York college for both their full time courses and part time courses again providing I have an apprenticeship, so far I have had one interview with a big York plumbing firm but due to the limited apprenticeships available there it is a long shot.
If anyone could help me or knows of any companies within the York area that are looking to hire people it would be greatly appreciated.
Thanks
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to Plumbing jobs in York? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
194
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
492
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
440
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
249
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
231
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock