Gas regs

Post new thread

Discuss Gas regs in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
C

Cazasjohnston

Could anyone please show me or tell me a page in the gas regs where it says copper and mild steel can only be jointed mechanically. Thanks
 
Am doing commercial cat 2 and i need to prove how it is jointed.
 
Status
Not open for further replies.

Reply to Gas regs in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

M
Unvented discharge at high level current regs
Hi they used to say as a last resort you could discharge the D2 pipework at high level and turn it back to the wall. Similar to a combi boiler. I...
Replies
11
Views
371
Matt0029
M
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
312
Dave Moore
D
S
Using coil to clear pipe leading to gutter
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and...
Replies
2
Views
166
Sonya K
S
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
246
dreikher
dreikher
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
477
Chuck
C

Newest Plumbing Threads

Back
Top