Search the forum,

Discuss Frozen Condensate! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

PaulGas

First one since winter! New boiler aswell....Installer has put condensate pipe through cavity (upstairs) to outside then put it up to 1 1/4" on the elbow, down, then another elbow, reduced to overflow pipe again.BACK INTO THE HOUSE (kitchen) and run the condensate into the sink trap. Dogs dinner and toally pointless!!!
 
Even better if the condensates thawed out by the time you get there! Cup of tea, concilatory noises, Drop of lagging if you're feeling generous and a nice wee boiler reset!
 
Status
Not open for further replies.

Reply to Frozen Condensate! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello I am looking to install a slimline dishwasher (integrated) into a cupboard in my kitchen. The depth of the dishwasher is 550mm and the depth of my cupboard is larger than this. The issue, however, is that the waste pipe which leads from the sink (next door cupboard) comes out quite a...
Replies
22
Views
464
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
247
S
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
2
Views
114
S
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
268
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
213
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock