S
simon0703
Hi everyone. Got a hardly used fatmax technician tote. Also testo digi manometer in need of calibration. In glos area, open to noffers. Cheers
- Thread starter simon0703
- Start date
- Replies 3
- Views 1K
- testo
Discuss fatmax and testo in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Reply to fatmax and testo in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi,
I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new...
Hi,
My current hot water system needs to be replaced.
Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Hello all,
I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Newest Plumbing Threads
-
Y Plan central heating gets hot on hot water demand
- Started by MPGASANDPLUMBING
- Replies: 0
-
Grant boiler rusting inside after 1 yr
- Started by RayPlumb
- Replies: 5
-
Instructions say to apply glass cement to rubber washer. Can I use silicone?
- Started by JM Tiling
- Replies: 2
-
How do I remove the copper pipe from the plastic connector?
- Started by JM Tiling
- Replies: 2
-
Pressure reducer/regulator for plastic water line?
- Started by carpetguardian
- Replies: 1
-
Cold water issues in the top bathroom
- Started by Apex84
- Replies: 2
-
