Discuss Expansion Vessel and water hammer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
165
Good morning, I've just been asked that if someone has a tap which shuts of the water abruptly, such as the cartridge valve taps and water hammer occurs, would fitting a small expansion vessel close to the tap relieve this? To be honest I have no idea but I can find the logic to this question.

Any ideas folks? Thanks.
 
Yes it can help sometimes but not in all circumstances.

It depends what the cause of the hammer is to be honest.

Have you checked the mains stop tap ?
That's always a good starting point.

You could fit one and maybe you'll hit jackpot first time but it's not a definite cure !
 
It should do the trick. The air will compress and water will not. It like putting a damper on Newton cradle.
 
Good morning, I've just been asked that if someone has a tap which shuts of the water abruptly, such as the cartridge valve taps and water hammer occurs, would fitting a small expansion vessel close to the tap relieve this? To be honest I have no idea but I can find the logic to this question.

Any ideas folks? Thanks.
It also could actually just be the cartridge.
 
Good morning, I've just been asked that if someone has a tap which shuts of the water abruptly, such as the cartridge valve taps and water hammer occurs, would fitting a small expansion vessel close to the tap relieve this? To be honest I have no idea but I can find the logic to this question.

Any ideas folks? Thanks.
if you read my post started 22.3.17 see if it sounds similar to your water hammer. i fixed it by fitting a double check valve really close to the stopcock . { house side} easy job and cheap! £5.85 from toolstation. hope this helps!
 
If it's a fitting or fixture then non returns would suffice or if it's pressure problem causing it then a shock arrestor .
 
a lot of times the quater turn cartridges are causing issues like this but I agree to the above of @kris has said.
 
Status
Not open for further replies.

Reply to Expansion Vessel and water hammer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

hello we have an unvented system. we have an issue where the hot water is hot for 10 seconds and then luke warm, turn off taps / wait and turn...
Replies
5
Views
728
Hi I've got water hammer issues with my cold feed and some with the hot feed. When the cold sink tap, cold bath tap and thermostatic shower in...
Replies
1
Views
452
Hi I have a baxi duotec combi boiler that every day or other day needs topping up as pressure drops below 0.5bar. When fired up it can reach...
Replies
2
Views
419
Hi all. Just had a neighbour knock the door regarding a water hammer issue. My own house developed this issue sometime last year as well which is...
Replies
2
Views
421
Hi, I have an unvented water heater which for some reason every year causes me issues. At the end of 2023 I noticed that the pressure valve...
Replies
5
Views
541
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock