Search the forum,

Discuss Easy Question: BAR Pressure issues.... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

aquaboy

Newbie Simple Question - BAR Pressure

Hi,

I have a very simple question.

I can't turn my Radiator Thermostat on my Boiler above 2, otherwise my BAR Pressure needle goes into the Red.
How do I correct this? My own theory is too release some water out of the Radiators. Just want to check with you guys. Thanks in advance.

IMG_0715.jpg
 
Hi,

I have an issues with the BAR Pressure of my Radiators....

I have too top the water up about 4 times a year, probably only half a cup full in total.

Anyway, for this winter I've had the Radiator Thermostat set to 2 because any higher and the BAR needle goes into the Red.
This means the Radiators are luke warm.

Today, I drained some water from the Radiators, and manage to get the Radiator Thermostat to 6, the BAR Pressure needle was just outside the Red and the Radiators where very hot. But when I turned of the heating, the BAR Pressure dropped and I got a warning light and I had to top the water up again.
IMG_0715.jpg

Help and Advice would be appreciated.

Thanks in advance.
 
Not a fault you can fix yourself.

You need a gsr in.

We cannot and will not give advice on the installation or repair of boilers, cookers or ANY gas appliances for your own safety.

Please go to Gas Safe Register | Ensure your gas engineer is registered. or post a thread in the 'I'm looking for a plumber / gas engineer' section of these forums remembering to include your location. [DLMURL="http://www.ukplumbersforums.co.uk/im-looking-plumber-gas-engineer/"]I'm looking for a Plumber or Gas Engineer[/DLMURL]

If you are gsr please increase your post count to 10+ then send a PM (Private Message) with your gsr details to either Gas man - View Profile: gas man - Plumbing Forum | Plumbing Advice | Plumbers Forums | A forum for plumbers advice in the UK or Redsaw - View Profile: REDSAW - Plumbing Forum | Plumbing Advice | Plumbers Forums | A forum for plumbers advice in the UK who will check you and then give you access to the gsr private forum.

Providing gas-related advice to anybody who should not be touching gas and cannot prove their competence is unacceptable. We will take whatever action we deem appropriate to prevent such advice being given


Thank you.

UKPF TA's, Mods and Admin teams.

[DLMURL="http://www.co-gassafety.co.uk/deaths.html"]CO Gas Safety[/DLMURL]

http://www.ukplumbersforums.co.uk/central-heating-forum/42241-notice-gas-safety-related-advice.html
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to Easy Question: BAR Pressure issues.... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Can central heating / gas engineer expert help me with below issue. During winter time only, I have been having issue with low pressure or pressure dropping with unvented hot water cylinder system. During summer time there is no usage of central heating so the pressure at unvented system is not...
Replies
0
Views
589
Greetings. I have an external Worcester Bosch Heatslave boiler and have a question about pressure. The boiler pressure was set to 1.5 during a recent visit by a plumber (as it seemed to have dropped and was hovering between the green and red zone) . A few days later I turned the thermostat down...
Replies
4
Views
534
Greetings. I have an external Worcester Bosch Heatslave boiler and have a question about pressure. The boiler pressure was set to 1.5 during a recent visit by a plumber (as it seemed to have dropped and was hovering between the green and red zone) . A few days later I turned the thermostat down...
Replies
4
Views
437
Good afternoon, I am experiencing a pressure issue with my heating system and was hoping to receive additional insight as to what the problem could be. We have a biomass boiler and stratification tank set up and recently had an issue with boiler pressure dropping off when the system was cold...
Replies
9
Views
366
R
Hi, I have boiler Vaillant VUW SOE 242_2-3 R2 (it's TurboBlock Pro). Does somebody have service manual / maintenance PDF where can I get some additional informations? Here's my problem: I'm not sure at what bar should I pump the chaimber (pre-charge pressure at bars). When I turn on the hot...
Replies
0
Views
310
Revlyne
R
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock