Discuss Changing radiators with a Boilermate 2000 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
G

gjlatz

Hello all,

The house builder on installed single rads in most of the rooms on our house. After last winter (up here in Scotland) I promised myself that I would replace the single rads with double (single fin) ones.

Apart from shutting the thermostatic valves, lockshield valves, draining the rads then replacing them is there anything else to watch for with on of these systems (Boilermate)?

Many thanks

Gjlatz
 
simpsons-homer---doh---popart-4003143.jpg
berzinga
 
Status
Not open for further replies.

Reply to Changing radiators with a Boilermate 2000 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
My daughter's place has a small water leak on a ground floor radiator valve. The radiator pipework is small diameter.i.e 8 or 10 mm. A plumber...
Replies
3
Views
410
Hi everyone. Apologies - I'm new, but I promise to try and be an active member of the forum :) We're doing some decorating just now and it was...
Replies
6
Views
941
Hello I want to replace the old single panel rad in the bedroom with a K2 double panel Stelrad one. I think I'm OK in general and relatively...
Replies
3
Views
955
I am asking this here because it is almost impossible to get a local plumber to answer the phone at the moment! Must be a busy time of year. I...
Replies
6
Views
2K
My 3 way actuator valve has gone on my central heating. I think it's a combination of the valve motor burning out due to a stiff valve on the...
Replies
1
Views
1K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock