Search the forum,

Bar shower mixer ID required please...

Post new thread

Discuss Bar shower mixer ID required please... in the Ireland area at PlumbersForums.net

G

Gordon T

Plumbers Arms member
Plumber
Gas Engineer
Messages
120
Can anyone identify the make ans model of this shower please? Thank you. G.

View: https://*********/Br6X2xq
 
Cannot remember name fitted a load of them on a contract. Cheap & cheerful certainly not worth repairing. Any bar shower will fit £40 upwards at screwing with a guarantee no brainer.
 

Reply to Bar shower mixer ID required please... in the Ireland area at PlumbersForums.net

Similar plumbing topics

M
Mixer mixer shower, compatible with tanked supply
Can anyone remember the Mira mixer shower that would work down to a really low pressure on a vented hot water system without a shower pump?
Replies
2
Views
93
Last Plumber
Last Plumber
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
97
Lou
Lou
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
191
SimonG
SimonG
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
196
ShaunCorbs
ShaunCorbs
C
Mira shower mixer adjustment.
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
224
cheddarman
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock