Discuss associations in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
9
Hi I'm looking to join an association for the plumbing heating and gas industry

eg CIPHE but one that helps... not just takes your money anyone got any experience with this..

thanks Baz
 
im with ciphe and apart from a few letters after my name and a monthly magazine i dont really get much else from them
 
Depends what "help" you are after. There are a few but most are only beneficial to employers.
 
im with ciphe and apart from a few letters after my name and a monthly magazine i dont really get much else from them

Think you are stretching it a bit calling it a magazine :skep:

But am a member and very much believe in the organisation and membership just wish they would flex their mussels a bit more,almost like they can not make their mind up were in the industry they want to stand

imho
 
Yeah, Im a CIPHE member too and know where your coming from puddle. They seem too cosy with the Government these days, they should be shouting out what the industry is going through.
 
Think you are stretching it a bit calling it a magazine :skep:

But am a member and very much believe in the organisation and membership just wish they would flex their mussels a bit more,almost like they can not make their mind up were in the industry they want to stand

imho

very very well said Puddle.

they've got a nice office though :smartass2:
 
Status
Not open for further replies.

Reply to associations in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't...
Replies
6
Views
358
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
404
Hi All, I am looking to take my bath out and fit a shower. Regards to tanking. Is it ok to just seal everything with plastic rather than just...
Replies
3
Views
284
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer...
Replies
2
Views
183
Hi they used to say as a last resort you could discharge the D2 pipework at high level and turn it back to the wall. Similar to a combi boiler. I...
Replies
11
Views
367
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock