G
gates1979
How do you use a Compression Fitting 3 Part Reducers and are they any good
Discuss 3 part reducers in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 10,619
larger part goes in fitting smaller in nut olive in between and yes they are as good as any compression fitting
B
Billy Bob Bob
totally agree the one parts are crap will only use three part
- Status
Reply to 3 part reducers in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall)
Unfortunately turning this to the closed position only reduces...
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking?
This originally happened about 12 months ago and has happened 3-4 times since.
It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Capping a redundant gas cooker supply
- Started by Jocky B
- Replies: 0
-
-
Water pump to regulate high pressure?
- Started by Nikileaks
- Replies: 2
-
Any advice for putting this shower in ?
- Started by Staggersandfalls
- Replies: 2
-
king of pipes no reply from private message
- Started by cjg
- Replies: 1
-
-
-
Why pressure gauge drop without leak
- Started by sanju pradeep
- Replies: 6
-
Hot water so hot tap and shower via our hot water tank
- Started by thecar
- Replies: 4
-
-
Running copper pipework above / across a Gas boiler?
- Started by kristeva
- Replies: 2
-
Installing pipework to avoid airlocks
- Started by Matt0029
- Replies: 1
-
DUK Pipes for thermostat shower fitted at different heights
- Started by Delforkids
- Replies: 2
-
-
