Search the forum,

3/4 olives used in 22mm compression on imperial pipe...

Post new thread

Discuss 3/4 olives used in 22mm compression on imperial pipe... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
W

WaterTight

Esteemed
Plumber
Subscribed
Messages
5,439
What size olives do I need - presuming I do exactly the same (???) - to use 28mm compression?
 
I know I could have said what's the next imperial size up in pipe but I also want to check if it's the same principle for every pipe size up in size excluding 15mm or whether some aren't...
 
Status
Not open for further replies.

Reply to 3/4 olives used in 22mm compression on imperial pipe... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
189
ShaunCorbs
ShaunCorbs
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
253
Chuck
C
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
245
DIwhYdidIstartThis
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
232
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Advice
Tiling Forums UK
UK Tiling Forums
Tile Cutters
DIY Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock