Discuss 2 zone controls with combi in the Plumbing Zone area at PlumbersForums.net

Status
Not open for further replies.
K

Ktm640

Hi all,

We have just had an extension built which will have a new 938 Vaillant combi boiler for CH and hot water.

This will replace a Baxi back boiler in the existing part of the house.

We are installing a new central heating system in the older part of downstairs and throughout the upstairs (the downstairs in the new extension will have underfloor heating).

Building regs state there must be two zones and rads must have TRV's.

Can anyone recommend a good package that includes the zone valves and room stats ?

The ones I've seen all seem to include a cylinder stat that we won't need.

The new boiler will be in a purpose built utility room. Would you normally install the tee to the two zones at the end of the copper coming off the boiler and then install the two zone valves immediately after the tee?

Thanks in advance
 
I pop to the merchant and ask for 2 of those and 2 of those and 2 of those and it all depends on whether the customer wants to spend more or less as to which make is used, simple really.
 
How many bathrooms in the house for that combi to be supplying? Have you considered a heat only boiler/system boiler and an unvented cylinder ?
 
Done deal I think
How many bathrooms in the house for that combi to be supplying? Have you considered a heat only boiler/system boiler and an unvented cylinder ?
 
Last edited:
How many bathrooms in the house for that combi to be supplying? Have you considered a heat only boiler/system boiler and an unvented cylinder ?

Considered it but went for a large combo with small in built tank instead
 
Sounds like you've chosen your system. An unvented cylinder would be the preferred option in my opinion. Your local merchant should be able to help you on the controls side if you choose to go with the 937.
 
Status
Not open for further replies.

Reply to 2 zone controls with combi in the Plumbing Zone area at PlumbersForums.net

Similar plumbing topics

Afternoon Fellas If anyone has time to help with this snag it'd be much appreciated. We have a wet-floor system controlled by John Guest UH3 and...
Replies
2
Views
500
A bit of clarification - I have extended a 3 bedroom semi detached and at the time central heating pipes were going in I told the plumber could I...
Replies
0
Views
481
We have UFH throughout downstairs. I have had one coil replaced. I have had the thermostats checked that they are linking to the correct...
Replies
8
Views
626
Hi. A new house regulation for a 2 zone heating system because it's bigger that 150sqm. I'm I right in saying zone 1 should be all of the...
Replies
10
Views
2K
HI folks, this post is a follow up to my post relating to my single pipe heating system. In summary, I have a house built in 1980 (I bought it 2...
Replies
8
Views
896
Back
Top