Search the forum,

Sewer inspection shaft

Post new thread

Discuss Sewer inspection shaft in the USA area at PlumbersForums.net

B

brobinson1

Messages
2
Hi
Can I extend my 100mm sewer inspection shaft up through new slab for shed?
Thanks
 
From a technical perspective, I cannot see why not. You may need to check local legislation to see if this needs to be approved by, or notified to, the authorities.
 

Reply to Sewer inspection shaft in the USA area at PlumbersForums.net

Similar plumbing topics

sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
522
Chuck
C
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
245
DIwhYdidIstartThis
D
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
DIwhYdidIstartThis
D
U
Below Ground Soil Pipes on Self Build Bungalow
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
116
umiq88
U
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical News
Tile Cutters
Tiling Forums
Electrician Talk Forum
Tile Talk
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock