Search the forum,

Discuss Searching for stopcock, what’s this please? in the USA area at PlumbersForums.net

Messages
2
Hi all, just moved in to a new house and currently searching for the stopcock, this is under the kitchen sink, I’ve turned it on and off but doesn’t seem to do anything. Any ideas what it is for please?

Also, any ideas where else the stopcock might be?!
Many Thanks
A79615C9-B609-4309-8D8A-1075AB36EAE1.jpeg
 
Some homes have mains stopcock in strange places and can be a result of extensions to the house done in the past.
Try careful check around the kitchen sink units or in airing cupboards etc.
 
Hi all, just moved in to a new house and currently searching for the stopcock, this is under the kitchen sink, I’ve turned it on and off but doesn’t seem to do anything. Any ideas what it is for please?

Also, any ideas where else the stopcock might be?!
Many ThanksView attachment 42482
As its a new house find the water meter or stop outside. Black circular disk 6 inch dia. Lift lid with flat head screwdriver and see what’s inside might even have a water key in there. Centralheatking
 
Any ideas what it is for please?

As others have said, that is the feed for a dishwasher or washing machine. The blue valve handle is the service vale (isolator) for the supply to the machine.

The white box with red nut is an anti-flood device. The grey hose coming out of the bottom is actually a hose within a hose. The inner hose carries the water and the outer ribbed hose is there to contain any water if the inner hose bursts. If the hose inside bursts, the whole thing will fill with water until it reaches the white box. When that happen it lifts a float inside and shuts off the water supply, just to that machine, and prevents a flood.
 

Reply to Searching for stopcock, what’s this please? in the USA area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
157
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
311
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
244
Hi all, I'm installing a concrete patio out back. By the wall under the kitchen sink I have an existing P-Trap gully for the grey water from the sink, dishwasher, washing machine etc. When I pour the concrete there won't be any chance to dig it up anymore. From my own research I get the...
Replies
0
Views
139
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
231
P
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock