Search the forum,

Replacing Cooke & Lewis RICCI bath mixer cartridge - no grub screw

Post new thread

Discuss Replacing Cooke & Lewis RICCI bath mixer cartridge - no grub screw in the DIY Plumbing Forum area at PlumbersForums.net

H

homebrewer55

Messages
1
How do i replace the quarter turn cartridge on this cooke & lewis ricci bath mixer tap .
Normally there is a grub screw somewhere to take the handle off, but for the life of me i cannot find one on this mixer.
Any helpful suggestions would be greatfully received.
 

Attachments

  • BathTap.jpg
    BathTap.jpg
    215.3 KB · Views: 6

Reply to Replacing Cooke & Lewis RICCI bath mixer cartridge - no grub screw in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
112
Lou
Lou
R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
1
Views
86
Lou
Lou
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
243
exedon2
exedon2
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
195
SimonG
SimonG
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
286
oz-plumber
O
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock