B
benny_headland
Hello all! Just a quick question! Does anyone know of the correct way of testing a pcb board with a multi meter? If so could you run me threw it!
Iv test components before with just a basic continuity test ( I.e. on an air pressure switch whilst blowing lightly threw It to check its working, or just a fuse or flow switch etc....
But just wondered what the correct way was of testing the pcb board is! Checking the resistance or what ever.....
Iv test components before with just a basic continuity test ( I.e. on an air pressure switch whilst blowing lightly threw It to check its working, or just a fuse or flow switch etc....
But just wondered what the correct way was of testing the pcb board is! Checking the resistance or what ever.....