Search the forum,

indirect

An election with electoral delegates is an election in which voters do not choose between candidates for an office, but elect people who then choose. It is one of the oldest forms of elections, and is used by many countries for heads of state (such as presidents), cabinets, heads of government (such as prime ministers), and/or upper houses. It is also used for some supranational legislatures.
Positions that are indirectly elected may be chosen by a permanent body (such as a parliament) or by a special body convened solely for that purpose (such as an electoral college).
In nearly all cases the body that controls the executive branch (such as a cabinet) is elected indirectly. This includes the cabinets of most parliamentary systems; members of the public elect the parliamentarians, who then elect the cabinet. Upper houses, especially in federal republics, are often indirectly elected, either by the corresponding lower house or cabinet. Similarly, supranational legislatures can be indirectly elected by constituent countries' legislatures or executive governments. The indirect democracy is run by electoral college or president

View More On Wikipedia.org
  1. M

    Boiler pressure is rising? Did indirect hot water tank coil fail?

    First post as I can not figure this one out. I have a hot water boiler heating system, gas fired, with an HTP SuperStor indirect hot water tank. I'm on well water and have a water softener and two whole house filters for my water. Three days ago I found my high pressure relief valve tripped...
  2. S

    Sporadic Hot Water - Unvented indirect

    Good Afternoon all, I am hopeful someone may be able to offer some guidance on the following. In the home we have a gas boiler (serviced annually, October time) providing hot water to the CH system which is split into 3 zones (Honeywell 2-way valves) and it also heats the HW tank (Tribune...
  3. P

    Unvented Cylinder Single coil heat pump vs twin coil solar

    Hi, I'm looking to purchase a 300L unvented indirect cylinder to work with a standard heat only boiler. I may have solar panels in the future, but likely the PV kind rather than the thermal kind, and won't be having heat pump in the future. So the cylinder would be connected to the boiler at...
  4. P

    Isolating hot water supply - indirect unvented cylinder system

    Hello, I am fitting new taps and a shower mixer in my en-suite and was looking to isolate the hot water pipes. I have an unvented indirect heating system (have attached some photos). I was wondering if the isolation valve that would shut off the water to the hot water taps is as circled in the...
  5. A

    Vibrating hot water return pipe from indirect cylinder

    Hi, I have two indirect water cylinders (Gledhill) connected to a gas boiler (Vaillant). The system is setup/programmed so that the tanks heat up twice a day for about 2 hours. When the tanks start to heat, one of them makes a loud vibrating noise, sometimes for about 15-20 mins, sometimes for...
  6. C

    2 cold feeds to indirect hot water tank

    Hi, I am reinstating an indirect hot water tank and have 2 cold water feeds coming into it from the same supply. One of the feeds has a float valve but what ever was on the other has been removed. Why would there be 2 feeds to the top of the tank? Can I blank one off and just use the float valve...
  7. F

    Elson Sapphire - Drain Down and Refill Procedure

    I have an Elson Sapphire double feed indirect hot water tank and I need to drain down the system to move some radiators. Would anyone be able to offer any advice as to the correct drain down and refill procedure for this tank? It is a self contained boxed and insulated unit with a single cold...
  8. F

    Elson Sapphire double feed indirect hot water tank

    Hi, I have a fairly modern multifuel stove with a back boiler connected to a Elson Sapphire double feed indirect hot water tank and I need to drain down the system to move a radiator. Would anyone be able to offer any advice as to the correct drain down and refill procedure for this tank as...
  9. O

    UK Cylinders ProLite Air twin coil solar indirect unvented 300ltr

    Hello! I have a new Vaillant boiler being installed and will install a new cylinder at the same time. Our installer is recommending a UK Cylinders ProLite Air twin coil solar indirect unvented cylinder 300ltr. According to specs the standing heat loss is 1.80 kWh/24h which seems pretty decent...
  10. J

    ARISTON CLASSICO UNVENTED INDIRECT CYLINDER ST1 210

    Hi All, looking for some advice. I have ARISTON CLASSICO UNVENTED INDIRECT CYLINDER ST1 210 which has corroded at one of the main inlets and is leaking water when in operation. This unit is now obsolete and need to source a replacement. Obviously I am aware that I cannot replace the unit myself...
  11. B

    Condensation on underside of Ariston Contract STI 150 Indirect Protect

    Hi guys - I have recently noticed that when the hot water is switched on I'm getting a little moisture on the underside of my Ariston Contract STI 150 Indirect Protect (one or two drips on the carpet under the unit after the hot water has been on for 20-25mins). When the hot water is not...
  12. M

    Continuous noise from indirect water cylinder

    I have moved into a house with a Joule Cyclone CY200L indirect cylinder in my loft. Recently it seems to continuously be making a noise, as if it's filling up or heating up, I'm not sure which. The thermostat on the side is set to 55, when I turn it below 50 there is a click and then the noise...
  13. R

    Vented indirect cylinder venting issue

    A customer of mine lives in an old cottage that has been extended. They have three loft areas that are completely separated. The CWSC is in one higher loft space, the hot water cylinder and shower pump live in another lower loft. They are on different sides of the building. There is single 22mm...
  14. R

    UK Normal unvented indirect tank or high gain unvented indirect tank

    Hi, Trying to decide which cylinder to go for? I am renovating my house which will end up having four bathrooms and a wc. I am planning to go for a 300l unvented indirect cylinder as currently I have a vented cylinder with a cold water tank in the loft and face issues with hot water pressure...
  15. D

    Electric boiler and an unvented indirect hot water cylinder

    Hi, I have recently purchased a cottage with an LPG combi boiler (no mains gas in the area). I intend to replace this with an electric boiler and an unvented indirect hot water cylinder. The boiler will run four radiators and the hot water cylinder. The cottage has one bedroom. What size (kw)...
  16. S

    URGENT New Gledhill Stainless Lite Indirect Unvented alarming popping noises.

    Happy Christmas everyone, We’ve just had a new Gledhill Stainless Lite indirect unvented cylinder installed by Dyno. It is making an alarmingly loud popping noises when the hot water is being used, not always but very very often. Mentally to me, it seems like the inner casing of the cylinder...
  17. N

    Unvented indirect with low pressure mains

    Hi, I live in a 9yr old 3 story townhouse with showers on the 1st and 2nd floor, a bath on the 1st and toilets and basins on all three floors. I've never been very happy with my shower and tap water pressures but have only recently investigated the issue. The house has an unvented indirect...
  18. N

    anti-corrosion additive on indirect water heater

    My current system is a wood fired boiler, and /or oil boiler the wood boiler heats my garage, home (hydronics) and my indirect HW system. the oil boiler does the 2 hydronic zones but not the garage. it also does my indirect hot water. The indirect tank is 32 years old and needs...
  19. R

    Ariston STI 150, unvented indirect cylinder.

    My house (old) has a heating system installed with a Protech Anti corrosion system, I don't know how old the cylinder is, which is showing signs of rust from around the Protech box! I can see the outside skin of the cylinder is thin mild steel, but thought the core was stainless steel? Is such...
  20. P

    Solar compatible cylinder Gledhill SunSpeed 2 Open Vented Indirect Twin Coil Solar Cylinder

    Hello I had a solar thermal installation. However, the Gledhill Stainless Steel Lite keepings making popping noises. Anyway, I was looking to have it replaced with another cylinder and found this one: Gledhill SunSpeed 2 Open Vented Indirect Twin Coil Solar Cylinder | Vented Cylinder -...
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock