Search the forum,

Part 2 float connection?

Post new thread

Discuss Part 2 float connection? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

M

macka09

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,226
Hi guys

What connection goes on to the part floats please? It looks like it should be a compression to me rather than tap connector?

I’ll add a pic

Cheers
 

Attachments

  • IMG_6609.jpeg
    IMG_6609.jpeg
    557 KB · Views: 6
Either or with those ones.
I usually use a tap connector with fibre washer so that it will suit any type when it is inevitably replaced in the future.
 

Reply to Part 2 float connection? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

S
Using coil to clear pipe leading to gutter
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
1
Views
52
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
dreikher
dreikher
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
226
Dave Moore
D
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
199
mutley racers
M
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
119
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Forum
Electricians Talk
Tiling Tools
TilersForums.co.uk
Tilers Forums UK
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock