Search the forum,

Discuss notifying unvented cylinder in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

markfxy

Plumbers Arms member
Plumber
Messages
989
I don't do enough unvented to justify paying my cps scheme for unvented, does anyone know the procedure for registering direct with building control?
 
Pretty sure you can Mark , but that is still a costly price depending on your council
 
Errrr you don't do enough?
As you know, you shouldn't be doing any.
 
Its simple, phone your local building control and inquire, they will then give you a control number for a fee. They will inspect and sign off if all is proper and if not charge you the same again to do the same again after whats not correct is rectified. I did the same with an annex I built and saved a good amount of money but I doubt that very much concerning an un-vented cylinder when a registered guy could do it when part of a competent persons scheme for a couple of quid
 
Last edited:
why shouldn't I be doing any then chalked maybe you know something I don't?
 
Just like gas safe. If your not part of a competent persons scheme. Your not meant to work on it. If you are G3 registered, I apologise. then you can notify them yourself.
 
You only need to be competent to install but registered to register its all straight forward
 
IMG_0041.PNG
You only need to be competent to install but registered to register its all straight forward
To be classed as competent, you need to be G3 registered.
 
I am, have been for years just seems a waste of money paying for cps when I might only do 1 or 2 a year
 
The competence is to have the certification to install, but to register you have to pay either way
 
I've got the certification to install g3 lasts for five years what I don't want is to pay nappit/nic every year
 
FYI building control will want around 150-200
 
Status
Not open for further replies.

Reply to notifying unvented cylinder in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Fitted unvented hotwater cylinder building control looking forms signed it off job was in england i am qualified northern ireland send out a form to fill in what do u need to sign off in england as building control said they dont give out forms like they do in northern ireland
Replies
4
Views
204
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
298
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
Does anyone know where I can get one of these? Toilet is leaking into the bowl. This one pushes in with a half turn but I can't find one anywhere.
Replies
2
Views
199
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
524
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock