Search the forum,

Discuss magnaclean on new build help please in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
7
Hi All

little advice please

I have moved in to a new build and the boiler is high up on the wall in a cupboard and the pipes go straight up in to ceiling so can put it on the retun.

I would like to fit a magnaclean professional 2 the only place I can fit it is in the main bathroom on the 2nd floor in where the hot tank is but i'm stuck as i have 2 heating zones.

1.jpg


4.jpg
 
thanks for all the help much appreciated

only problem I have is the magnaclean fits vertical
could i fit a 28mm elbow at out side of the pump so it horizontal then elbow down to the magnaclean them back to the the return
 
thanks for all the help much appreciated

only problem I have is the magnaclean fits vertical
could i fit a 28mm elbow at out side of the pump so it horizontal then elbow down to the magnaclean them back to the the return
You may be better with the TF1 compact, as that can be installed horizontally. It might save you some headache and it’s a good filter.
 
And put a bit of pipe insulation on the hot outlet pipe from top of cylinder.
Odd that the discharge pipe has been insulated
 
thanks for all the help much appreciated

only problem I have is the magnaclean fits vertical
could i fit a 28mm elbow at out side of the pump so it horizontal then elbow down to the magnaclean them back to the the return

Yes you can & easily done. The other guys have mentioned other makes of filter as well, which are good; but each to their own. I do prefer to stick with the Magnaclean myself.
 
thanks I picked the Magnaclean due research on the others reliability on leaking and efficiency as the Magnaclean i got does the magnetic and non magnetic in the water. Ill measure up to see the space and not to block other parts on the tank
 
all reviews i found on the sprirotrap is the magnet is too weak to go through the brass body and falls off it. the leaking on the magaclean is due to cross threading the cap over tightening not cleaning it properly
 
all reviews i found on the sprirotrap is the magnet is too weak to go through the brass body and falls off it. the leaking on the magaclean is due to cross threading the cap over tightening not cleaning it properly

The Fernox TF1 omega is brass bodied, compact and can be fitted horizontally and has powerful neothingy magnet centrally located too. Seemingly bulletproof and I've moved over to them from Spiro
s.
 
Last edited:
shame they don't last as long as the warranty just going by what i have found online I know you can trust it all

That all depends on the insulation if it's chucked on the wall and installed in half a day any boiler won't last long

Get a decent insulation/ installer and it should last 10-15 years with servicing
 

Reply to magnaclean on new build help please in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
117
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
242
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
323
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
231
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
126
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock