Search the forum,

Discuss Hot water problem Greenstar 28i junior in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

Deleted member 99291

Having a few issues with shower going cold. It is ok early morning before 7am but after this time goes cold after a few mins.

Would this be the heat exchanger or something else. Water pressure is weaker later in the day so wondering if this is the issue.

Thanks
 
If it's ok before a time it's not the boiler
 
Never really have the hot taps on long enough. This has only started heppening over the last week or so since the massive pipe burst in Birmingham in the news. We are only a couple of miles away.
 
Could you try the hot taps for long enough?
 
Just ran the hot water taps for several minutes and all was fine.
 
I would say it's the shower then
 
Shower takes hot water directly from the boiler, would it be a thermostat?
 
Shower takes hot water directly from the boiler, would it be a thermostat?

Thermostat cartridge in the shower yes or could be the filters on the shower inlets as you've said the water main burst
 
Try turning down the domestic hot water thermostat at the boiler. The shower may struggle to mix properly if the water is too hot and the flow is reduced.
 
My guess is local water board have turned local pressure down. You may need to re calibrate your shower. Basically pull to temp knob off, turn it (past the stop) until it’s hotter, then replace the knob. Easy
 
Status
Not open for further replies.

Reply to Hot water problem Greenstar 28i junior in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
150
Hi, Later this year I am going away for a 2 week holiday and as the weather will be warm there is no need for the heating to be on and arguably no need for me to needlessly heat hot water. My intention was to turn the boiler off along with the mains water when going away. Now, I have heard...
Replies
1
Views
108
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
311
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
157
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
366
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock