Search the forum,

Flue supporting clips

Post new thread

Discuss Flue supporting clips in the Plumbing Jobs | The Job-board area at PlumbersForums.net

H

Honeymonster

Messages
2
Is it ok to use rubber lined steel pipe clamps as a flue supporting clips?
 
Like these?

9173C35F-EAC5-4F6B-8FA9-BA58C739B9B8.jpeg
 
Yes you can confirmed from most manufacturers tbh there better than the standard ones

Hate Worcester ones gloworm are better (clip wise)
 
Or just use a 5” rubber liner clip
 

Reply to Flue supporting clips in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
210
mutley racers
M
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
DIwhYdidIstartThis
D
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
195
ShaunCorbs
ShaunCorbs
C
Is it necessary to earth bond a Kitchen Sink?
I am in process of replacing an existing sink with a new stainless steel one. The existing tap is plumbed directly to copper which means that it is earthed. The new tap will use flexible tails and so will not be earth bonded. My initial search for information suggests that there is no legal...
Replies
6
Views
237
pritchardsplumbing
P
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Standards BS5389
UK Tiling Forum
Electrical Advice
Tiling Forum UK
British Standards in Tiling BS5389
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock