Search the forum,

USA estimated water usage by outpatients in health care clinics

Post new thread

Discuss estimated water usage by outpatients in health care clinics in the Plumbing Jobs | The Job-board area at PlumbersForums.net

L

liquidspaces

I am searching for design estimate of daily domestic (non potable) water usage by outpatients in health care facilities. The only data I found was about Guidelines for minimum emergency water quantity for outpatients which is 5 liters/out-patient.
I would appreciate any data about regular daily water usage by out-patients in plumbing fixtures and not just the minimum emergency storage recommendation that I found on Sphere (2004)
 
Sorry for missing your point. From the name and description, the Tilers Forum is about tiles. I do not see how it is related to my question which is related to plumbing.
If you think that this particular forum is not the right one for the question, I would definitely do a simultaneous search elsewhere and keep checking for any feedback in this forum also.
 

Reply to estimated water usage by outpatients in health care clinics in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Chuck
C
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
DIwhYdidIstartThis
D
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
268
ShaunCorbs
ShaunCorbs
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
338
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Plumbers Forum - Plumbing Advice
Tiling News
Tilers Forum
Tiling Forums UK
Tiling Tools
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock