Discuss Doc m cistern what is the name for the lever mechanism in the Australia area at PlumbersForums.net
- Messages
- 1,337
Toilet handle or toilet lever. I would advise purchasing a brass one, usually chrome finish as the cheap plastic ones often fail early. The arm that sits inside the cistern comes with the handle as part of the kit and the majority of them are adjustable so they will suit many different situations. Any plumber's merchant or DIY store will stock them.
Reply to Doc m cistern what is the name for the lever mechanism in the Australia area at PlumbersForums.net
Similar plumbing topics
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Does anyone know where I can get one of these? Toilet is leaking into the bowl. This one pushes in with a half turn but I can't find one anywhere.
We are from Alberta, and I own an electrical company.
I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Hi all
Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Boiler losing pressure only on central heating- Started by SnosRap75
- Replies: 1
-
tanking. Is it ok to just seal everything with plastic.
- Started by Staggersandfalls
- Replies: 2
-
Pop quiz, does anyone recognise this radiator valve?
- Started by dimuc
- Replies: 3
-
SUsing coil to clear pipe leading to gutter
- Started by Sonya K
- Replies: 1
-
Replacing outdoor P-Trap Gully with Bottle Gully
- Started by DIwhYdidIstartThis
- Replies: 0
-
-
-
-
-
Mixer mixer shower, compatible with tanked supply
- Started by Matt0029
- Replies: 2
-
-
No Hot water, Fixed and Broken Again Ideal Logic 24
- Started by Filthbags
- Replies: 2
-
-
What's happening to this radiator, paint flaking off?
- Started by mikmikmikmik2024
- Replies: 3
-
Is it necessary to earth bond a Kitchen Sink?
- Started by Cello
- Replies: 6
