Discuss Digital Thermostat in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

Jd67

I am thinking of changing from old thermostat to digital. There are 3 wires in old one but only need 2 in digital. The grey wire is not needed what is grey wire for
 
You should have

Live Brown or red
Neutral Blue or black
Earth Copper/ earth sleeve
And switch live/ call for heat grey

These should be right but either get a spark or heating eng to confirm
 
Salus RT300 Digital Room Thermostat £25 What is this thermostat from B&Q like compared to this Honeywell THR840 also from B&Q £35
 
I cant comment on the honeywell but ive fitted loads of salus rt300/500 and not had a problem.
They are cheap functional and if installed correctly in a smaller property (i.e not a 3 storey monster) they work just fine when installed and frequency set correct
 
Just purchased the Salus RT500 Digital Room Thermostat. 2 wires one L other SL What is the SL
 
Switched live. Basically your thermostat will close this (send current) down the SL to tell the boiler to fire up.
 
Help. Can't figure out wiring. Old manual one wiring was Brown live into no1-Grey into no3- Black into no 4. When power is on there is power in brown and grey. Nothing in black. The digital has 2 wires Live goes to Live but which wire Grey or Black goes to SL. Tried Grey in it but heat will not switch on. Afraid to connect Black incase something fuses.
May have to get electrician although had hope to cut cost.
 
if you have 3 wires one will be live from the boiler the other will be switch live back to the boiler (call for heat) the other will probably be a neutral, but if you are not sure and cant use an electrical multimeter to check then you need to get either a gas engineer or and electrician to do it for you
 
Status
Not open for further replies.

Reply to Digital Thermostat in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
336
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new...
Replies
2
Views
256
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
227
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
Replies
1
Views
323
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic...
Replies
2
Views
237
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock