Search the forum,

DeWalt Phone

Post new thread

Discuss DeWalt Phone in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Shocked to see the Caterpillar phone comes complete with an IR capability! :56:
 
My jcb workphone is over 5 years old. Its been burnt, dropped and even run over. Still going though :)
 
just want the thermo camera ;)

the rest is just rubish all you need is a 'love mei' case on any phone, there bomb proof.
i saw a samsung galaxy edge with one fitted, it fell out a car window at 40mph and all it had was a small dent on the corner of the case!!
 
Debating one of these for when I take the dive into self employment.
 
Status
Not open for further replies.

Reply to DeWalt Phone in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
138
Lou
Lou
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
252
Chuck
C
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
240
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
139
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Cutters
Tiling News
Electrical Forum for Electrical Advice
Tile Blog
Contractor Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock