Master Soldering help needed for a clean solder

[Electronurd]

Easier soldering the outside of the pipe than the inside of the fitting but the result is the same.
Well done on getting those jars to hang there. Bet that was harder to do

Thanks. No the jars was the easy bit honestly.

Better pictures the right way up here:

https://drive.google.com/open?id=0BxLXOZBjHN-7ZTFvbmpEQW1GdUk

This is just the first tier. There's going to be three tiers in total.

 

[ShaunCorbs]

looking good

 

[Electronurd]

looking good

Cheers Shaun... would have done it without your obvious insight to solder from the inside.

 

[ShaunCorbs]

also if your looking for somthing to cap it off / feet

ROUND PLASTIC BLACK BLANKING END CAP CAPS TUBE PIPE INSERTS PLUG BUNG STEEL

 

[Electronurd]

also if your looking for somthing to cap it off / feet

ROUND PLASTIC BLACK BLANKING END CAP CAPS TUBE PIPE INSERTS PLUG BUNG STEEL

Well the plan is to have 3 tiers(as we collect spices and use them all the time) and attach it to the kitchen wall using munsen rings. Once finished I'll post more pics.

 

[plumbill]

You could use "solder paint" if you can still get it. This was a paste of powdered solder and flux mixed. You apply to the joint and heat with a torch. Might work.

 

[ShaunCorbs]

You could use "solder paint" if you can still get it. This was a paste of powdered solder and flux mixed. You apply to the joint and heat with a torch. Might work.

Not wras approved sorry to say

 

[plumbill]

Not wras approved sorry to say

Light fittings don't have to be WRAS approved!

 

[ShaunCorbs]

Light fittings don't have to be WRAS approved!

No but anyone looking at this thread thinking of using it on plumbing systems, you didn't say it couldn't be

 

[zzzjim]

Light fittings don't have to be WRAS approved!

You never know , if its being used in a controlled area , Bathroom / Kitchen !