Discuss G3 - structural survey for installation of unvented? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
277
You need to notify BC obviously and I understand you need one if it's going in the loft to comply with G3 but what if it's being installed on the ground floor and there are no structural issues to consider do you still need to get one done to tick the box?

I overheard it being discussed and the later didn't make a whole lot of sense to me, I'd be grateful for some clarification.
 
As above, not needed prior to installation , but does and should be done after.
 
Status
Not open for further replies.

Reply to G3 - structural survey for installation of unvented? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

As part of a rebuild (added 1st floor to bungalow and extended back) we have removed every piece of plumbing and electrics, during COVID In...
Replies
10
Views
1K
So I bought my first flat recently (am in UK) and in a bit of a pickle as the bathroom has turned up lots of problems that weren't picked up by...
Replies
1
Views
740
    • Like
Hello, my Mothers heating failed in the recent UK cold snap. I found the pump was stuck. I have a question about pump orientation. The...
Replies
8
Views
690
Hi, Can I pick your brains? My boiler is often reluctant to start, sometimes it does, sometimes it seems that it will if the demand is from the...
Replies
19
Views
1K
Hi guys I've done my G3 in December as I needed to fit an unvented cylinder in a restaurant. I said to the client to notify BC about the...
Replies
15
Views
3K
Back
Top