Discuss Soldered pipe advise!! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

Samantha1

Hi I wonder if someone could please advise me if a soldered join on a radiator pipe is possible to leak after 2 weeks? Thanks :001_icon16:
 
Yes if installer didn't do it properly and it's a gravity system. Un likely on a pressurised.
 
How would I know if it's pressurised, sorry my plumbing knowledge is not great! X
 
It flooded out floor x we have a video of water damage but not the leak... X
 
I would expect any soldered joints to be water tight for a long while. 2 weeks indicates an incorrectly soldered fitting, unless there has been some sort of mechanical damage.
 
Status
Not open for further replies.

Reply to Soldered pipe advise!! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
241
I have discovered a very old end feed 22mm t connector under the bath is very gently weeping water. It’s in a place and with pipework that are...
Replies
2
Views
225
Hi All, I hope you are doing well. I have a problem. Not sure if this was always like that or something is degrading. Whenever the toilet...
Replies
4
Views
324
Hi All, I hope you are doing well. I have this 3.25mm lead-free grade 99c solder wire. I know that the good practice to bend the wire before...
Replies
7
Views
957
Hi, Short version: I have about 4" of pipe sticking out of a concrete floor in a cupboard. It makes a 45-degree bend as it exists (bent, not with...
Replies
14
Views
1K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock