- Messages
- 37
The water is only Luke warm only. ....Is that Luke warm with heating on or just hot water only?
So before testing, the water was like warm, the immersion was off and made sure the water was cold where possible.
The hive pressed hot water boost 30 minutes at 25 degrees. Duration of 14 minutes remaining, the water was only Luke warm. And the full 30 minutes, the water was only Luke warm. Felt the pipe work surrounding the hot water cylinder and it was warm / cold. The boiler displayed 75 reading on screen with 1.9 bar.
I also noted when I pressed cancel hot water on the hive, the drayton zone valve - the black clip slides downwards.
Test number 2.
Immersion switch off.
Hive boost both hot water and heat and within 14 minutes, felt the pipe work connect to hot water cylinder heat picking up and gradually 25 minutes very hot. Noted the display on the boiler was 35 with bar 2.4.
Not sure what the issue could be. Tried calling the valliant installer back, but still awaiting to hear back at present.
Any help / advice would greatly appreciate. Thanks a lot.
Last edited: