Vented CH system

Status
Not open for further replies.
U

Unregistered

Hi, recently moved house and it has an open vented system with f/e tank in loft. Had an issue with the f/e tank overflowing with hot water and cold spots on rads. Drained system down and added sentinel X400, overflow seems to have stopped and radiators are becoming a bit better than they where.

When system is on it sounds as if there is water running into cylinder in cupboard, the water is not coming from the f/e tank which is full during running but not overflowing. When central heating is shut down then the cylinder fills as normal from the f/e tank and seems as if it does for a good few mins. To me it seems as if cylinder when running is at a low level and there is a return of hot water trickling back into it?

I don't have much experience with this system so any help would be appreciated. My next step was to drain flush and then remove the worst affected rads and flush with a hose.

Thanks in advanced.
 
Please register with us and start a new thread to receive an answer to your question.
 
Status
Not open for further replies.

Similar plumbing topics

Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
487
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
429
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
362
Back
Top