unvented and secondary return circulation

[heatman]

have a job to fit albion 300L unvented(indirect) and secondary return circulation+ bronze pump on return, im using 22mm pipe to feed
1 bathroom
2 ensuites
util sink
basin in toilet
kitchen

Question1, is the pump to be on 24/7 or timered (conserned about legionella)

Question2, when looking at unvented manual it says
"On large secondary circulation systems it may be necessary to incorporate an extra expansion vessel into the circuit to accommodate the increased system water volume"

Pipe capacities (copper)
15mm o/d = 0.13 litres per metre run (10 litres = 77m)
22mm o/d = 0.38 litres per metre run (10 litres = 26m)
28mm o/d = 0.55 litres per metre run (10 litres = 18m)

job req about 30meters of 22mm

does any body have info on what size extra vessel is required?

Question 3 what size insulation would you recomended on secondry return pipes?

thanks for any advice (btw yes i have unvented ticket)

 

[Deleted member 2053]

FYI legionella is a naturally occuring bacteria, it lays dormant in water and can be found naturally in water sources such as rivers, lakes and reservoirs. the only way to fully remove the bacteria is by pasturation which occurs at 60^C, so by some feat of 'magic' do you think that the waterboard heat all the water supply for the entire country prior to feeding it through our mains water supply?

Legionella will multiply and breed most efficiently in stagnant water at 37^C, this is why you maintain a system turnover every 24 hours and keep hot water above 50^C minimum and cold water delivered at no more than 20^C

There are lots of myths and misunderstanding about legionella and your comments are a classic example. Read the ACOP L8 it tells you all about it!

No I obviously don't think that tap water is pasturised but perhaps I was foolish enough to think that the treatments the water board had were capable of keeping us alive. I'm amazed the human race has survived this far.

H&SE are experts at making knee-jerk reactions based on partial info. When I have a bit of time it will be interesting to read some of the papers on Legionella studies and see just how competent they have been this time. If you have a few hours to spare read 'Scared to Death' by Booker and North.

 

[unguided1]

Hi all
I was always under the impression that you had more chance of finding legionella in a shower head, where the temperature of the water is lower and is dispenced through a spray. I also have been lead to believe (I still am not sure if its true)that very soon there are to be new regs stating that water from an outlet should be no hotter than 45 degrees, what happens then?
mind you knowing me, Ive got it wrong and look forward to being put right.
regards
Mike

 

[migoplumber]

no mike your totally right, and yes the regs are changing again.
was on the phone to hvac yesterday because this whole post bugs me a bit, just cause i cant get my head round throwing hot water through your towel rail.
alph has it right. if you read l8 you can interprete a lot of things as you like.
there will be a clear statement in next ammendment about this type of installation
my head got filled with gobbledygook, just talking to the man!

shaun

 

[alph250]

Hi all
I was always under the impression that you had more chance of finding legionella in a shower head, where the temperature of the water is lower and is dispenced through a spray.

No your completely right legionellosis can only be harmful to us in an aerosol form and thats exactly what showers produce, However the biggest risk and which is usually overlooked is AHU with heater or cooler batterys in them, only if the condensate is not drained away and maintenance isnt kept up, the condensate will be at a temperature which legionella will multiply (lets face it plant rooms are usually around 35^C!) and then get circulated through the normal ventilation route, google Gillian Beckinsdale, it was a court case a few years ago.

The other high risk in the domestic area is jacuzzi's, think about it bubbles creating aerosol and what temperature is the water at? Theres been alot of people in the past becoming ill from these, even within showrooms!

 

[A H & P]

I've just come across this forum whilst looking for clarification on the legionella question. My angle is I have installed solar panels on my roof, an unvented cylinder and system boiler. In the mixed summer days we get in this country I can get between 65 deg and 43 deg at the bottom of my 250ltr cylinder, obviously it is going to be hotter at the top of the cylinder but I don't have a stat in there.
So I've turned my boiler off, as anything over 40 is hot enough for a shower or bath, but is legionella an issue ?
I don't want to have to use gas to lift the temp to 60 only to then mix it back down to 40. I was told by a cylinder rep that legionella isn't an issue with unvented and i have read the same on an ariston unvented pdf, but I am looking for a "official" answer if poss.

 

[migoplumber]

lots of the larger cylinders i work with, have anti "stratisfication" pumps on them.
basically a pipe from top of cylinder, joined to the bottom of the cylinder with a bronze pump.
helps keep the cylinder tempereature equal from top to bottom, and wont confuse your stat to thinking everything is ok when its sat on top of cylinder reading 65 degrees, whilst at the bottom you have a lovely 40.

i imagine the same principle works for smaller cylinders.

shaun

 

[heinz57]

I did the legionaire course, got shouted at by all these funny french blokes in poofy hats chasing me across the desert. By the way, frogs legs taste like chicken but ya can keep the fuc#ing snails.

But seriously, is it worth doing the legionella course, its about £90 if im not mistaken but the basics are covered in the water regs! All for health and safety but £90!!!

Will surely read the above recommended leaflet - peace out.

 

[Plouasne]

The CIPHE design guide has a page on Legionella, and it cost only £40 to non members and I think £25 for members, half the price of going on a course

But if you like and when I can find it, I could post the actual French legislation on hot water cylinder and the risk of Legionella, and the methods of prevention

 

[radswilldo]

The CIPHE design guide has a page on Legionella, and it cost only £40 to non members and I think £25 for members, half the price of going on a course

But if you like and when I can find it, I could post the actual French legislation on hot water cylinder and the risk of Legionella, and the methods of prevention

Oh yes please, could you also post the legislation from Botswana and Peru, cheers