A
Annamh
Can someone please advise how I can remove these top fit bolts…..
Discuss Toilet seat ideal standard removed of fixings in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Reply to Toilet seat ideal standard removed of fixings in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Similar plumbing topics
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Does anyone know where I can get one of these? Toilet is leaking into the bowl. This one pushes in with a half turn but I can't find one anywhere.
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one.
Granddaughter just moved house and this valve decided to leak when it was closed.
When open its fine.
Normally I have repacked the gland on...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Capping a redundant gas cooker supply
- Started by Jocky B
- Replies: 0
-
-
Water pump to regulate high pressure?
- Started by Nikileaks
- Replies: 2
-
Any advice for putting this shower in ?
- Started by Staggersandfalls
- Replies: 2
-
king of pipes no reply from private message
- Started by cjg
- Replies: 1
-
-
-
Why pressure gauge drop without leak
- Started by sanju pradeep
- Replies: 6
-
Hot water so hot tap and shower via our hot water tank
- Started by thecar
- Replies: 4
-
-
Running copper pipework above / across a Gas boiler?
- Started by kristeva
- Replies: 2
-
Installing pipework to avoid airlocks
- Started by Matt0029
- Replies: 1
-
DUK Pipes for thermostat shower fitted at different heights
- Started by Delforkids
- Replies: 2
-
-
