Search the forum,

Tap Conversion needed

Post new thread

Discuss Tap Conversion needed in the USA area at PlumbersForums.net

G

gazsnag

Messages
2
Hi,
I have a 2 in 1 laundry tap as pictured in the attachment.
I would like to convert it into a standard single tap fitting.
Please advise on how to do this.
 

Attachments

  • special tap.jpg
    special tap.jpg
    30 KB · Views: 11
Can you show us a picture of the tap or fitting you wish to replace, in situe, or where you intend to fit one? I'll be honest and say that I don't really understand your question so if we could see a picture of where you want to put the tap I might understand a little better.

Thanks.
 
That tap goes into an existing valve body, so you will have 2 outlets off the same body if you install that tap.
Hence, the 2 handles.

If you want the existing tap to do a washing machine or dishwasher (20mm hose connection) - go buy a washing machine stop tap.
If you want it to connect to a tap (15mm connection ) - go buy a mini stop tap.

There is no descent way of connecting that tap to 1 outlet, unless you cap off one outlet
 

Reply to Tap Conversion needed in the USA area at PlumbersForums.net

Similar plumbing topics

B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
181
ShaunCorbs
ShaunCorbs
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
215
DIwhYdidIstartThis
D
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
314
Timmy D
T
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
219
Dave Moore
D
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
88
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock