P
Peter N
Is there any clause that says I cant remove the rubber rind on a viega fitting and solder it on my domestic gas installation? Thanks
Discuss Soldering veiga fittings on gas in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Reply to Soldering veiga fittings on gas in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Similar plumbing topics
- Article
A Plumber Who Worked Illegally Gets A Suspended Sentence After Falsely Claiming To Be Gas Safe Registered.
A Plumber in Herefordshire was prosecuted after Hereford Trading Standards Team found that he was falsely claiming to be on the Gas Safe Register when he was not, putting members of the...
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one.
Granddaughter just moved house and this valve decided to leak when it was closed.
When open its fine.
Normally I have repacked the gland on...
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Pop quiz, does anyone recognise this radiator valve?
- Started by dimuc
- Replies: 1
-
SUsing coil to clear pipe leading to gutter
- Started by Sonya K
- Replies: 1
-
Replacing outdoor P-Trap Gully with Bottle Gully
- Started by DIwhYdidIstartThis
- Replies: 0
-
-
-
-
-
Mixer mixer shower, compatible with tanked supply
- Started by Matt0029
- Replies: 2
-
-
No Hot water, Fixed and Broken Again Ideal Logic 24
- Started by Filthbags
- Replies: 2
-
-
What's happening to this radiator, paint flaking off?
- Started by mikmikmikmik2024
- Replies: 3
-
Is it necessary to earth bond a Kitchen Sink?
- Started by Cello
- Replies: 6
-
Show us your fanciest radiators you have installed!!
- Started by Lou
- Replies: 4
-
Y Plan, no hot water but heating is working when called
- Started by Chopper9495
- Replies: 8
